sandrail or light off road rail - sold
Part number:
richard's rail
Description:
This rail has new:
frame off white paint job
front beam off black paint job
Douglas aluminum ball joint rims
brake lines (hard metal and stainless steel braided)
HD shift coupler
shift box bushing
axle boots
oil cooler with fan
optima battery
high torque starter
fuel filter after tank
10 x 40 (13 gallon) gas tank
throttle cable
seat covers
4 headlights
2 taillights
brake master cylinder
Comes with:
5" x 15" wide 5 pattern white spoke rims naked & loose
NEEDS:
new hard line fitting at the slave for the line that feeds the slave
BOTH rear brake rotors (would suggest wide 5 pattern) & new wheel bearing seals
new axle boot on drivers side (brand new boot took a stick and now has a hole!)
Neither Doghouse or the actual owner knows the true size of the engine, but it is an AE block (very desireable)
The carbs are Empi 40 HPMX's & have been tuned to the engine
Doghouse has:
repaired leaking brake line couplers & bled the brakes
opened the idle jets to 60's, adjusted carbs mix & idle screws
installed throttle cable, gas pedal, brake master cylinder
completely rewired switch box with all soldered & shrink tubed ends
tested fuel pump capacity & set at 4 psi
installed throttle return spring
installed new bleed valve & fitting for it on the slave
welded tab for throttle stop
removed fan shroud, fixed alt tins, replaced intake nuts
installed oil cooler, made engine run, made all lights work, installed new ignition switch, installed new axle boots & filled trans, relocated coil to top of shroud, installed new engine to trannny bolt
frame off white paint job
front beam off black paint job
Douglas aluminum ball joint rims
brake lines (hard metal and stainless steel braided)
HD shift coupler
shift box bushing
axle boots
oil cooler with fan
optima battery
high torque starter
fuel filter after tank
10 x 40 (13 gallon) gas tank
throttle cable
seat covers
4 headlights
2 taillights
brake master cylinder
Comes with:
5" x 15" wide 5 pattern white spoke rims naked & loose
NEEDS:
new hard line fitting at the slave for the line that feeds the slave
BOTH rear brake rotors (would suggest wide 5 pattern) & new wheel bearing seals
new axle boot on drivers side (brand new boot took a stick and now has a hole!)
Neither Doghouse or the actual owner knows the true size of the engine, but it is an AE block (very desireable)
The carbs are Empi 40 HPMX's & have been tuned to the engine
Doghouse has:
repaired leaking brake line couplers & bled the brakes
opened the idle jets to 60's, adjusted carbs mix & idle screws
installed throttle cable, gas pedal, brake master cylinder
completely rewired switch box with all soldered & shrink tubed ends
tested fuel pump capacity & set at 4 psi
installed throttle return spring
installed new bleed valve & fitting for it on the slave
welded tab for throttle stop
removed fan shroud, fixed alt tins, replaced intake nuts
installed oil cooler, made engine run, made all lights work, installed new ignition switch, installed new axle boots & filled trans, relocated coil to top of shroud, installed new engine to trannny bolt
We accept the following forms of payment:
